Introduction
This VESA mount is specially designed for LattePanda or other SBC cases. It can be used with VESA compatible display and monitor stand to hide the LattePanda or SBC behind the display, thus greatly reducing wire clutter and saving project space.
The mount supports common 10×10cm and 7.5×7.5cm VESA standards and offers screws with two lengths, which is suitable for most displays with VESA holes.
Besides, it contains the holes for directly using with LattePanda Titan series case and LattePanda V1 metal case. Meanwhile, two hook sliders are included and the distance between them can be freely adjusted, which allows users to conveniently install various SBC cases with hanging holes.
⚠Note
Please refer to display manual or consult the related technical support to confirm the maximum screw length allowed by the VESA mounting hole and choose appropriate screws or raiser columns for the installation because overlong screws may cause damage to LCD panel.
Please check if hooks are adequately spaced from circuit board inside the SBC case when mounting it with slide hook. For some compact cases, metal hooks may cause a short circuit and even damage hardware when they touched the circuit board.
Installaiton Steps
Install LattePanda case or other compatible SBC case on the mount.
Fix the mount to the VESA hanging holes at the back of monitor, or install it between the display and bracket.
Installation Schematic
LattePanda Titan Case
LattePanda V1 Metal Case
Slide Hook
Mount on Display Directly
Mount on Display with Raiser Column
This method is suitable for concave VESA mounts or display with uneven backside.
FAQ
For any questions, advice or cool ideas to share, please visit the DFRobot Forum.