The Maqueen Plus V3 motor replacement
This document introduces the c, helping users safely assemble, operate, and quickly get started with the robot.
Maqueen Plus V3 Motor Replacement Guide
The Maqueen Plus V3 features a replaceable motor design. If the motors are damaged due to high-intensity operation or accidental drops, follow the instructions below to replace the motors.
Motor Removal
Power off the Maqueen Plus V3.
Remove the two wheels.
Unplug the connecting wires from the motor. As shown in the figure:
Use a screwdriver to unscrew the 4 motor screws on the bottom. As shown in the figure:
Motor Installation
Install the buckle onto the motor. As shown in the figure:
Mount the motor onto the bottom plate. As shown in the figure:
Connect the wires. This step requires patience as the installation position is relatively cramped. As shown in the figure:
Install the wheels. During installation, align the flat surface of the motor shaft with the flat groove of the wheel to avoid installation failure or damage to the wheel shaft hole. As shown in the figure:
Was this article helpful?