Terminal Block Shield for Arduino Mega Wiki - DFRobot

Introduction

Has it ever happened to you that you spent a lot of time ascertaining a problem when making projects and finally found out it was just caused by loose wiring? Then, what you may need is a terminal block shield like this!

The shield adopts terminal blocks to secure wires so as to make connections stable and reliable. And multiple 3.3V, 5V, and GND ports are provided for easy wiring. It can be powered by 7~24V voltage without an additional buck-down circuit. The onboard 18pin-FPC socket makes it convenient for connecting a screen.

Features

Application

Specification

GDI 18pin-FPC

FPC PINS Beetle ESP32 C3 Pins Description
VCC 5V 5V
BLK (PWM dimming) D7 Backlight
GND GND GND
SCLK D52 SPI clock
MOSI D51 Host output, slave input
MISO D50 Host input, slave output
DC D2 Data/command
RES D4 Reset
CS D3 TFT Chip Select
SDCS D6 SD card chip select
FCS D25 Font library
TCS D5 Touch
SCL SCL I2C clock
SDA SDA I2C data
INT D19 INT
BUSY-TE D24 ripstop pins
X1 D23 custom pin 1
X2 D22 custom pin 2

Dimension Diagram

Board Overview

FAQ

Q&A Some general Arduino Problems/FAQ/Tips
A For any questions, advice or cool ideas to share, please visit the DFRobot Forum.

More Documents