CommunityForumWikiBlogLearn
Modules
Motors & Actuators & Drivers

Atmega8 Digital Servo Control Shield

SKU: DRI0027

The Atmega8 Digital Servo Control Shield integrates a half duplex circuit enabling communication with over 200 AX-12 servos through a serial bus, providing feedback on each unit's position, rotation velocity, torque, and more, making it highly suitable for wheeled and tracked robot applications.

Detail of Arduino Servo Shield with connection ports for robotics applications-DFRobot product sku:DRI0027 image.

Downloadable Resources

  • Docs
  • Tech Specs

    • Specification

    Parameter Details
    MCU Atmega8
    Power Supply 6.5-12V
    Compatibility Arduino R3
    SPI Interface with Arduino (Digital 10, 11, 12, 13)
    User Friendliness Friendly using for the primary user
    UART Interface for deeper development
    Servo Channels 7 channels for servo connecting
    Circuit A half duplex circuit inside
    Board Surface Immersion Gold
    Size 59x53mm

    Pinout

    pinout

    More Details

    • POWER SUPPLY: 6.5~12V power supply for servos & the whole system.
    • UART SELECT: UART is already shorted by solder. When you use the UART FOR ATmega8 please remove solder off.
    • UART FOR ATmega8: This UART interface is for deeper development of the shield.You can program the atmega8 on the board with FTDI.Board choose "Arduino Optiboot8 "
    • SS SELECT FOR SPI: Digital pin 10 in default.If you want to use other digital pins,please remove the jumper cap and connect the ss header to other Arduino digital pin.

    Was this article helpful?

    TOP