Reference
Last revision 2025/12/20
This article delves into the SRF08 ultrasonic rangefinder's communication protocol, focusing on its I2C bus interactions, address configurations, and the ability to operate multiple sonar devices simultaneously using the General Broadcast address.
Communication Protocol Description
Communication with the SRF08 ultrasonic rangefinder is via the I2C bus. This is available on popular controllers such as the OOPic and Stamp BS2p, as well as a wide variety of micro-controllers. To the programmer the SRF08 behaves in the same way as the ubiquitous 24xx series eeprom's, except that the I2C address is different. The default shipped address of the SRF08 is 0xE0. It can be changed by the user to any of 16 addresses E0, E2, E4, E6, E8, EA, EC, EE, F0, F2, F4, F6, F8, FA, FC or FE, therefore up to 16 sonar's can be used. In addition to the above addresses, all sonar's on the I2C bus will respond to address 0 - the General Broadcast address. This means that writing a ranging command to I2C address 0 (0x00) will start all sonar's ranging at the same time. This should be useful in ANN Mode (See below). The results must be read individually from each sonar's real address.
For detailed working principles, register configuration, and communication mechanisms of the ultrasonic ranging module, please refer to the official SRF08 technical documentation.
Was this article helpful?