CommunityForumWikiBlogLearn
Sensors
Range & Distance Sensors

Gravity: Analog Adjustable Infrared Sensor Switch

SKU: SEN0164

The Gravity Analog Adjustable Infrared Sensor Switch offers precise detection capabilities with adjustable range settings for both opaque and transparent objects. Powered by a 5V supply, it consumes less than 25mA and has a response time of under 2ms. With a detection angle of 15° and a range of 3 to 40cm, it outputs low voltage when objects are within its scope. The sensor requires a pull-up resistor when connecting to MCU pins and is encased in a plastic shell measuring 30mm x 20mm x 13mm with a 45cm lead wire. Pin connections include RED for VCC, YELLOW for Signal, and GREY for GND.

Angled shot of back of adjustable infrared sensor switch with buttons and three-wire cable connected for Arduino distance sensing.-DFRobot product sku:SEN0164 image.
  • Docs
  • Tech Specs

    • Specification

    Parameter Value
    Power supply 5V
    Control Output 100mA when supply 5V
    Circuit consume <25mA
    Response time <2ms
    Direction ≤15°
    Range 3~40cm adjustable for opacity and transparent objects
    Shell material plastic
    Output Feature A low voltage output will be given when a object is in its detecting scope
    MCU Connection Note When connect to MCU pins, you need to add an 1~10K Ohm resistor for pull-up
    Sharp 30mm(length) x 20mm(wide) x 13mm(thickness) with a 45cm lead wire

    Pinout

    Adjustable Infrared Sensor Switch Dia

    • RED--->VCC
    • YELLOW-->Signal
    • GREY-->GND

    Was this article helpful?

    TOP