Example Code for Arduino to Read Raw Value of Fermion: MEMS Odor Sensor

This project demonstrates how to read the raw analog value from the Fermion: MEMS Odor Sensor using an Arduino board. Users will learn how to connect the sensor to the Arduino, read the analog output signal, and view the raw sensor values via the serial port monitor.

Hardware Preparation

DFRduino UNO R3 (or similar) x 1
MEMS Gas Sensor x 1
Jumper wires

Software Preparation

Arduino IDE

Wiring Diagram

SEN0563

Other Preparation Work

The module needs to be warmed up for more than 5 minutes when powered on for the first time. It is recommended to warm up for more than 24 hours if it has not been used for a long time.

Sample Code

int sensorPin = A0;
int sensorValue = 0;

void setup()
{
  Serial.begin(9600); //Set serial baud rate to 9600 bps
}

void loop()
{
  sensorValue = analogRead(sensorPin);
  Serial.println(sensorValue);
  delay(100);
}

Result

Open the serial port monitor and get the original value of the sensor.

Example Code for Arduino-Read Sensor Raw Value