Example Code for Arduino to Read Raw Value of Fermion: MEMS NO2 Sensor

This project demonstrates how to read the raw analog value from the Fermion: MEMS NO2 Sensor using an Arduino board. Users can learn how to connect the sensor to Arduino and retrieve the analog output value.

Hardware Preparation

DFRduino UNO R3 (or similar) x 1
MEMS Gas Sensor x 1
Jumper wires

Software Preparation

Arduino IDE

Wiring Diagram

SEN0563

Other Preparation Work

The module needs to be warmed up for more than 5 minutes when powered on for the first time. It is recommended to warm up for more than 24 hours if it has not been used for a long time.

Sample Code

int sensorPin = A0;
int sensorValue = 0;

void setup()
{
  Serial.begin(9600); //Set serial baud rate to 9600 bps
}

void loop()
{
  sensorValue = analogRead(sensorPin);
  Serial.println(sensorValue);
  delay(100);
}

Result

Open the serial port monitor and get the original value of the sensor.

Example Code for Arduino-Read Sensor Raw Value