Usage Example for PC-Module Setting
Last revision 2026/01/06
This article offers a practical guide for setting up a PC-Module with a UHF RFID Reader and DFRduino UNO R3, including a detailed wiring diagram.
Hardware Preparation
- ID01 UHF RFID Reader-UART(SKU: TEL0082) ×1
- DFRduino UNO R3 (SKU: DFR0216) × 1
- USB Cable × 1
Wiring Diagram
The wire definition of UHF RFID MODULE-UART is:
- red：Input 7V/2A
- black：GND
- green：TX end
- yellow：RX end
Notes:
-
When connect with arduino board using chip ATmega328P, please exchange the TX/RX port if you want to send command from usb terminal.
-
Using serial to send command from PC, we need to exchange RX/TX.
Was this article helpful?