Receiver Configuration Guide
This guide offers step-by-step instructions for configuring a receiver, including pairing with transmitters and switching between different operational modes such as inching, latching, self-locking, and interlocking. It also explains how to clear pairings and manage transmitter codes effectively.
Receiver operating instructions
Pairing
- step1. Click the button of the receiver(Press and hold for <0.5S), the blue indicator light next to the button will light up, and the receiver waits for pairing.;
- step2. Make any channel of the transmitter continuously transmit signals within six seconds, until the blue indicator light of the receiver flashes 3 times, then the pairing is successful;
- step3. The blue indicator light flashes three times after the pairing is successful, and it will light up again. At this time, the next transmitter can be paired. If there is no next transmitter to be paired, it will automatically exit the pairing mode after waiting for 6S;
- Note: The pairing waiting time is 6S, if the pairing signal from the transmitter is not received within 6S, the pairing mode will be automatically exited.
- Note:After the pairing is successful, the transmitter must re-transmit the signal and the receiver can receive it. If it fails, repeat the previous two steps.
- Note: You only need to pair any one of the transmitter D0~D3 signals, and the other three will automatically match.
Mode switch
Note: The receiver is in inching mode by default, the following examples all take inching mode as an example. If there is no requirement for using other modes, you can skip this step
| Mode | Description |
|---|---|
| Latching | After D0 receives the signal once, it stays high until D1~D3 receive the signal |
| Self-locking | Each time D0 receives a signal, the corresponding output state is inverted once, the same is true for D1~D3 |
| Inching | D0 receives the signal and outputs high level, but does not receive the signal low, the same is true for D1~D3 |
| Interlocking | When receives the signal D0, D0 stays at a high level, and all the others are low. The same applies to D1~D3. |
Press and hold the button for 0.5~1.5 seconds, then release it, the blue indicator light flashes twice, indicating that you have entered the mode switching state, and then you can enter different modes according to the different times of pressing the button within 6 seconds:
Press once to enter the latching mode;
Press twice to enter the self-locking mode;
Press 3 times to enter the inching mode;
Press 4 times to enter the interlocking mode;
According to the mode you need to enter, press the button for the corresponding number of times, and then hold the button for 0.5~1.5 seconds as a confirmation signal. After letting go, the blue indicator light flashes 2 times to set successfully and enter the corresponding working mode. 0.5-1.5 seconds is relatively short, be careful not to press overtime.
Clear pairing
The receiver can store up to 32 sets of transmitter codes. When there are more than 32 sets, the first paired code will be overwritten;
Clear all paired transmitters: Press and hold the button on the receiving end for more than 4 seconds. After releasing your hand, the blue indicator light flashes twice to successfully clear all paired transmitters; if the clearing fails, repeat the above operation.
Was this article helpful?