Getting Started
Last revision 2025/12/25
This article provides a comprehensive guide for beginners on setting up and using a 0.96inch 128x64 IIC SPI OLED Module with DFRduino UNO R3, including hardware and software requirements, wiring diagrams, and library installations to enable easy integration and use.
Hardware Preparation
- DFRduino UNO R3 (or similar) x 1
- 0.96inch 128x64 IIC SPI OLED Module x 1
- M-M/F-M/F-F Jumper wires
Software Preparation
- Arduino IDE
- Download and install the 0.96" 128x64 u8g2 Library. (About how to install the library?)
- Download and install the [0.96" 128x64 DFRobot_GDL Library] (Not released yet)
Wiring Diagram
The IIC address is 0x3C
It is recommended to use Arduino 1.8.9 and above.
Was this article helpful?