Network Tools
This article explores the configuration of network tools including WIFI, AP Hotspot, and Ethernet settings, offering guidance on accessing gateway systems via IP addresses to ensure optimal connection management.
Network Tools
In the Network Tools, parameter settings for three functions—WIFI, AP Hotspot, and Ethernet—are provided.
- Only one of WIFI or AP Hotspot can be used at a time.
- After connecting to Ethernet and enabling the Ethernet function, the WIFI connection will be disconnected.
After connecting to WIFI, the gateway configuration system can be accessed via the connected IP address within the local area network (LAN). The location for querying the IP address is shown in the figure. To query the WIFI IP address, you can connect a USB cable to a PC, then enter 10.6.6.6 in the browser to log in to the gateway system.
After the AP mode is enabled, once the computer is connected to the AP, you can enter 10.8.8.8 in the browser to access the configuration system. As shown in the figure:
When the gateway is connected to the Ethernet via the network port, it is inconvenient to check the IP address to log in to the gateway system at this time. In such cases, you can check the IP address of the Ethernet connection by connecting the gateway to a computer via a USB cable or enabling the AP hotspot. After that, you can access the gateway system through the local area network (LAN) IP address.
Was this article helpful?