Example Code for micro:bit-Makecode
Last revision 2025/12/19
Write a program using Makecode (example code shown below), burn it to the Micro:bit, and observe the serial port output results.
Hardware Preparation
- 1 x micro:bit
- 1 x IO Expansion board
- 1 x Thin-film pressure sensor
- 1 x Digital cable
Software Preparation
Wiring Diagram
Connect the sensor to P1 pin of the expansion board.
Sample Code
Result
| When no pressure is detected |  |
 |
|---|---|---|
| When pressure is detected |  |
 |
Additional Information
Note: The greater the force, the higher the detected value will be.
Was this article helpful?