Gravity: Air780E 4G CAT1 Communication Module

SKU: TEL0179

The Air780E 4G CAT1 communication module simplifies IoT project development with its high data rates, extensive protocol support, low power consumption, and seamless connectivity through serial ports and USB interfaces, making it an ideal solution for efficient and rapid integration into various development environments.

Board Overview of Gravity: Air780E 4G CAT1 Communication Module
  • Docs
  • Tech Specs
  • 1. AT Command Handbook

    The AT Command Handbook offers a comprehensive guide on utilizing AT commands for module configuration, information querying, and troubleshooting. It covers common commands like AT+CGMI for manufacturer details, AT+CSQ for signal quality, and MQTT commands for efficient device management.

    2. Usage Example for Easy IoT Platform - MQTT Communication

    This article provides a detailed guide on setting up and using the Easy IoT Platform for MQTT communication, including hardware preparation, AT command usage, and step-by-step instructions for sending messages to a server.

    3. Usage Example for Raspberry Pi - Using 4G Module as Network Card

    This article guides you through using a 4G module as a network card on a Raspberry Pi, with detailed hardware preparation and operational steps to achieve stable internet connectivity.

    Specification

    Parameter Details
    Applicable regions China, India, Southeast Asia, and other areas
    Supported bands - LTE-FDD: B1/B3/B5/B8
    - LTE-TDD: B34/B38/B39/B40/B41
    Supported protocols TCP/UDP/PPP/HTTP/NITZ/NDIS/NTP/HTTPS/MQTT
    Speed 10Mbps (downlink) / 5Mbps (uplink)
    Low power consumption As low as 0.6mA in sleep mode, supports UART serial data wake-up and periodic interrupt wake-up
    Development mode AT commands
    Communication interface UART (PH2.0-4P Gravity interface)
    SIM card slot Nano SIM card
    Level compatibility 3.3V/5V
    Antenna interface SMA female connector (external thread, internal pin)
    Antenna specifications 4G/LTE 50mm elbow rubber stick antenna, SMA-J interface (SMA internal thread, internal pin)
    Power supply voltage - USB port: 5V
    - Terminal block: 5V-12V (recommended for long-term deployment)
    - UART interface: 3.3V-5V (this interface has lower power and may not ensure normal communication, only for testing)
    Operating Temperature -40°C ~ 85°C
    PCB size 42mm×37mm

    Pinout

    TEL0179-Functional Diagram

    Interface Name Description
    ANT Primary antenna interface, connects to GSM antenna
    UART UART interface (interface level 3.3V-5V)
    USB-typec USB device interface for communication and parameter setting with computer
    Power IN External 5V-12V power supply is required when using UART interface
    NanoSIM Card Insert SIM card

    Precautions:

    1. External 5V-12V power supply is required when the module uses PH2.0 socket for serial communication
    2. Net - Network signal indicator light
    • Blue light on for 0.2 seconds, off for 1.8 seconds: searching for network
    • Blue light on for 1.8 seconds, off for 0.2 seconds: standby state
    • Blue light on for 0.125 seconds, off for 0.125 seconds: data transmission state

    Note: This status prompt only applies to successful PPP dialing or AT command active PDP activation, successful RNDIS networking

    1. Short-term output of log information and debugging information during boot process

    Was this article helpful?

    TOP