SKU: DFR0923
This FireBeetle 2 expansion shield suits makers preferring terminal blocks for wiring. It adds 7-24V external voltage input and GDI port vs prior models. Terminal blocks secure wires for stable connections; each (except GND) has an LED for status, with an LED switch to turn off LEDs when not needed. It’s incompatible with FireBeetle ESP32-S3 and M0.
Downloadable Resources
1. Example Code for Arduino-Digital Port
The article is a guide to programming Arduino's digital port using FireBeetle 2 ESP32-E, including hardware setup, sample Blink code, and LED blinking results.
2. Example Code for Arduino-I2C Port
This article provides example code for using the Arduino I2C port with FireBeetle 2 ESP32-E and SHT40 sensor, covering hardware setup, software installation, wiring, and code execution.
3. Example Code for Arduino-Analog Port
This article guides readers through setting up and coding Arduino analog ports using FireBeetle 2 ESP32-E, including hardware preparation and sample code.
4. Example Code for Arduino-GDI Interface
This article provides a guide on interfacing Arduino with GDI, including setup and sample code to display '你好' on a TFT LCD.
Was this article helpful?
