CommunityForumWikiBlogLearn
Sensors
Switches & Buttons

BOSON Tilt Sensor i5

SKU: BOS0005

This tilt switch is a digital module based on the steel ball switch. The ball inside the module will roll to the lower side under gravity to have the switch connected or disconnected. You can also use it just as a tilt sensor. It supports digital output and has higher security than mercury switches. And the module can be used with maincontrollers such as micro:bit and Arduino, suitable for not only Mind+ and makecode graphical programming but also non-programming projects.

Boson: Tilt Switch
  • Docs
  • Tech Specs
  • Certifications
    • 1. No-Code Example for Tilt Alarm System

    This guide walks you through setting up a no-code tilt alarm system using a tilt sensor, buzzer module, and mainboard, highlighting hardware preparation, wiring, and system functionality.
    2. No-Code Example for Anti-theft Alarm for Gallery Exhibits

    The article explores setting up a non-programming anti-theft alarm system for gallery exhibits using various sensors and micro:bit components. It details hardware preparation, wiring diagrams, and the system's functionality, which triggers an alarm when exhibits are touched or tilted, providing a simple yet effective security solution.
    3. Code Example for micro:bit-Tilt Alarm System

    The article offers a comprehensive guide to building a micro:bit tilt alarm system, detailing necessary hardware and software, illustrating wiring diagrams, and providing sample code for programming. It describes the system's functionality of detecting tilt and activating a buzzer to alert users.
    4. Code Example for micro:bit-Anti-theft Alarm for Gallery Exhibits

    This article provides a comprehensive guide on setting up a micro:bit-based anti-theft alarm system for gallery exhibits, including hardware preparation, wiring diagrams, and sample code for programming, ensuring that any touch or tilt of the exhibits triggers an alarm.
    Reference

    Specification

    Parameter Value
    Operating Voltage 3V-5V
    Interface Type PH2.0-3P
    Dimension 26mm×39mm/1.02×1.54"
    Signal Type digital signal (0 or 1)

    Pinout

    NO. Label Description
    1 GND Power -
    2 VCC Power +
    3 SIGNAL Digital Signal Line
  • PFAS PFAS

    • Was this article helpful?

    TOP