Firmware Update
Last revision 2026/08/11
-
Connect the seeMote Cube to your computer using a USB data cable.
-
Download the appropriate version of AuTerm for your operating system.

-
Launch AuTerm and configure the serial connection:
- Click
Refreshto update the list of available serial ports. - Select the COM port corresponding to the seeMote Cube.
- Set the baud rate to
460800. - Click
Openin the upper-left corner to open the serial port.

- Click
-
Switch to the
Terminaltab, enterbootloader, and press Enter. When theEntering MCUboot serial recovery mode...message appears in the terminal, the device is ready for firmware flashing.

-
Download the firmware packageseeMote_Cube_User_FW_260820, then extract the
.binfirmware file. -
Switch to the
MCUmgrtab:- Select the extracted
.binfirmware file. - Select
No action. - Click
Goto start flashing the firmware.

- Select the extracted
-
Wait until the progress reaches 100%. Then select
OS→Resetand clickGoto restart the device.

-
The firmware update is now complete.
-
After updating the firmware, forget the previously paired device in the Bluetooth settings on Apple Vision Pro, and then pair it again.
-
Toggle Bluetooth off/on, or restart the Vision Pro after re-pairing.
Do not disconnect the USB cable or close AuTerm during the flashing process, as this may cause the update to fail.
Was this article helpful?
