Board Overview

Connectors

• USB Connector

  • power supply for Huskylens
  • connect to the computer to upgrade the firmware

• 4-pin Connector

  • power supply for Huskylens
  • connect to the controller board to read the results
  • can be switched between UART and I2C modes

• You can connect either USB port or 4pin port to power HuskyLens.
• Due to the onboard power supply automatic switching circuit, the USB port and the 4pin port can be connected to the power supply at the same time, and the power supply on the USB port is used first.
• Please ensure that the supply voltage and rate are sufficient to prevent HuskyLens from working abnormally.

Buttons

There are two buttons on the HuskyLens, the function button and the learning button. The basic operations of these two buttons are shown as follows:

• Dial the "function button" to left or right to switch different functions.

• Short press the "Learning button" to learn the specified object; long press the "Learning button" to continuously learn the specified object from different angles and distances; if HuskyLens has learned the object before, short press the "Learn button" to make it forget.

• Long press the "function button" to enter into the second-level menu(parameter setting) in the current function. Dial left, right or short press the "function button" to set related parameters.