General Settings
Last revision 2026/01/19
The article explains how to operate Huskylens general settings, including selecting, adjusting, and saving various parameters like protocol type, screen brightness, LED, and RGB light settings. It also covers menu auto-hide duration, factory reset, and language selection, ensuring users can effectively customize their device for optimal performance.
Basic Operation
The basic operation is shown as follows:
-
Select the general settings: Dial the function button right until the words “General Settings” is displayed at the top of the screen, then select it.
-
Enter the general setting mode: Short press the function button to enter it.
-
Select and adjust the parameter: Dial the function button left or right to select different parameter, then short press the function button to enter the parameter. Dial the function button left or right to adjust the parameter. Then short press the function button again to confirm the parameter.
-
Save the settings: After adjusting the parameters, dial the function button left to select "Save & Return", then short press the function button. A message “Do you save data?” will appear. The default seletion is "Yes". At this time, short press the funtion button to save and exit.
- The parameters in the general settings are all selected and adjusted by dialing "function button" left or right, and pressing the "function button".
- After setting the parameters, be sure to select "save and return" to save the set parameters.
Parameters Introduction
There are 10+ different parameter settings in the general settings.
| Parameter | Description / Options | Default Value |
|---|---|---|
| Protocol Type | UART (9600, 115200, 1000000), I2C, or Auto-detection. | Auto-detection |
| Screen Brightness | Adjusts screen brightness level (Range: 1 ~ 100). | 80 |
| Menu Auto-hide | Time delay before the menu automatically hides (Range: 1 ~ 100 seconds). | 10 seconds |
| LED Light | Controls the two front LED lights (ON / OFF). | OFF |
| LED Brightness | Adjusts the brightness of the two front LED lights (Range: 1 ~ 100). | 50 |
| RGB Light | Controls the front RGB light (ON / OFF). | ON |
| RGB Brightness | Adjusts the brightness of the RGB light (Range: 1 ~ 100). | 20 |
| Factory Reset | Resets Huskylens to factory settings. | — |
| Version | Displays the current built-in firmware version. | — |
| Language | System language options (Chinese / English). | English |
Was this article helpful?